15W pump setting bench can be used for both glassed and electronic measurement. Test pipes can move in 3 axis, which allows them to be connected to the bench without being bent. The test sets below can be mounted on EPS 815 pump setting bench and allow testing of new systems.

Technical Specifications

Dimensions WxHxD	1565 x 660 mm
Approximate weight	1,000 kg
Drive
Fully-protected special motor (thermal and overload)
Direct Clutch
Constant power (permanent)	10,2 kW
Transmission power (20 min.)	15 kW
Transferrable power (60 sec.)	17.5 kW
Rotational moment (continuous)
0 to 590 min-1	164 Nm
0 to 85 0min-1	-
At 1500 min-1	65 Nm
At 2,500 min-1	38 Nm
Rotational moment (60 sec.)
0 to 590 min-1	280 Nm
0 to 850 min-1	-
At 1500 min-1	111 Nm
At 2,500 min-1	67 Nm
RPM range	0-4000 min-1
RPM control precision	< ± 1 min-1
RPM control time
RPM setting and clutch speed	250 min-1/s
Rotational direction (left/right)
Injection start precision	0,1 °
Injection start chuck turning moment	1,5 kgm2
Axial height (Slide and chuck center)	125 nm
Clutch
ISO compliant coupling 12 / 24 V outlet	2600 Nm / °
Magnetic on/off	7 A
ISO oil transfer pump
Test oil low pressure	0 - 600 kPa 0 - 22 l/min
Test oil high pressure	0 - 6 Mpa 0 - 1,4 l/min
Pump lubrication pressure (special accessory)	0 - 600 kPa 0 - 5,8 l/ in
Manometers
Low pressure	0 - 600 kPa
High pressure	0 - 6 Mpa
Vacuum pressure / Internal pressure of the pump	0-100-0-250 kPa
Transfer pump fuel pressure	0 - 1.6 Mpa
Oil pump oil pressure (special accessory)	0 - Mpa
Heating / Cooling
Test oil heater, electrical, approximately	2.2 kW
Test oil cooler, coupling	G½ ISO 288
Cold water consumption, approximately	9 l/min
Filling quantity
Test oil, approximately	50 lt
Waste oil collection capacity	6 lt
Lubrication oil (special accessory), approximately	12 lt
Setting bench colours
Green	6018 RAL
Gray	7016 RAL